Mix engineers and producers tools like Subtractive EQ is a boon. It is one of the finest software which will help you get some of the best and well-balanced sound for vocals.

Here are seven unique tips that will help beginners to understand the usage as well as the processes:

Boost initially and then Cut

As a beginner, you might not be sure which portion must be eliminated. To identify the nasty parts, you must look for a big boost. You need to bring them out from the woodwork. Experts have some conflicting opinions about whether you should use it or not. Sweeping the boost means to move the frequencies encompassing the spectrum, while you are searching for the unpleasant sound.

Try to use Narrow EQ

The Q here stands for the width of the cut or boost. It is the number of frequencies, you are trying to swoop at one point in time. The higher is the value of the Q, the narrower it becomes. Therefore, in this ratio, we can say 20 is a narrow while, 1 is considered as broad.

Try to use transparent EQ

As a matter of fact, beginners know that color EQ adds pleasant harmonics, smearing and is also good for cutting. The EQ utilizes a slope that’s proportional and does not becomes narrow to lessen the level of attenuation. It suggests the Q is dynamic in nature and changes according to the proportion of the cut. To combat this equation, you can use Neutron 2’s EQ in a digital mode.

Do not overdo on the level of cut

If you cut the range in a very strict manner, the sound will not be natural anymore. It will sound as being processed and chock all the unpleasant sound together.

Try Dynamic EQ

At times, no matter how hard you have tried, a direct cut leaves the sound to be lifeless. It is so because the ear is prone to listening to natural sound, any abrupt cut will make the person alert that the sound is not natural at all. With the help of dynamic EQ, the ears will listen to accurate natural sound.

Use Boost up and Shape Cuts

It takes some time to figure out how to do it. Engineers might know how to use subtractive EQ and shape the cuts easily. However, with the use of an equalizer, you can filter shapes, adjust high or low pass and a parametric notch will work according to the internal architecture.

The Takeaway

These were the seven tips to use a subtractive EQ for beginners, you can take help from the expert engineers, but it’s better to try it yourself. No matter how you curtail frequencies, it is necessary to balance the natural flow of the sound even if you have to take cuts and shape them. To have better results, make sure you utilize these tips to use the tool in the best possible way.

 

Leave a comment

Your email address will not be published. Required fields are marked *